Piezo-resistive fluid-Check®
(Hydraulic oil DIN 51524 /CETOP RP 91 H )
and other mineral oils

DS-1-A-400-1/4" for serv-Clip® Type 1
(for mounting on pressurized industrial pipes)

DS-1-A-400-3/8" for serv-Clip® Type 2
(for mounting on non-pressurized pipes)

With the help of the pipe measuring connection SERVCLIP® (Made in Germany) YOU DO NOT NEED TO CUT THE PIPELINE FOR THE INSTALLATION. You need ONLY 3 MINUTES (up to 630 bar / 9100 psi). This intelligent connection is in all used pipeline diameters mm / Inch / R-Inch available.

YOU CAN INSTALL OTHER DETECTION ON SERVCLIP (FLOW RATE fluid-Check, LEAKAGE fluid-Check, TEMPERATURE fluid-Check) and manometers, gauges, particle meters, and much more.

Description of the sensor :
In addition to its robust and compact design, this sensor stands out by its high accuracy and its extensive measurement range. As a standard, the housing and all parts exposed to the liquid are made of stainless steel (Type 1.4571). The standard connection is G1/4“, with soft seals made of Viton.

Technical data
- Pressure range 0 ... 400 bar
- Output signal 4 ... 20 mA / 2 wires
- Operating temperature –20 ... 80°C
- Protection mode IP 65
- Right-angle plug connection DIN 43650 A
- Robust stainless steel housing
- Fully encased sensor element made of stainless steel

Ask about our MOBILE MEASURING SUITCASE FM-1-B for your practical measurements with SENSORS.