PIPE MOUNTED IN MINUTES-NO CUTTING WITH SERV-CLIP®!!!
A GOOD NEW FOR THE HYDRAULIC! SERV-CLIP® THE PIPE MEASURING POINT is a patented product and registered trade mark of BKM in Hagen-GERMANY.
- Connect into system UNDER PRESSURE up to 630 bar (9100 psi)
WITHOUT TUBING SEPARATION IN 3 MINUTES
- (incl. M16X2) ALLOWS CONNECTION OF SENSORS AND SCREWED COUPLINGS
CHECK IMMEDIATELY: Pressure, Temperature, Flow Rate, Leakage, Aqua content in oil,
Particle Contamination and more
- For Diameters : 10 to 42 mm + Imperial NB & OD and specials
How works serv-Clip®?
FAST ASSEMBLY (3 Minutes)
A needle is pressed through the wall of the pipe. It uses the principle of plastic deformation to create a leak-proof opening.
Good quality reasons :
-No contamination of the oil through swarfs
-Working pressure up to 630 bar.
-Viton O-ring (+200°C) is supported outwards always orthogonal towards the tubular axis.
The needle is conical and the leak proof is closed after the installation.
Measuring immediately - without tubing separation
OPTIONS :
Type 1: for mounting ON pressurized pipes
(no shutdown of your installations)
Type 2: for mounting on NON pressurized pipes (the most economical variation)
Installation of sensors, manometers or other devices possible.
Flow rate (*) fluid-Check®
Leakage (*) fluid-Check®
Pressure
Temperature (*)
Oil samplings
Aqua quote (*) Particle counters
Ventilation
(*) Only with Type 2 possible– for non pressurized pipes. –
