VeriCal™ In-Situ Calibration System for GF90 Flow Meter
Eliminates De-Install/Re-Install--Saving Time and Money

Ideal In Air Pollution Monitoring and Control Applications

With the new VeriCal™ In-Situ Calibration Verification System for the GF90 Air/Gas Flow Meter from Fluid Components International, plant technicians can confirm flow measurement accuracy in only minutes without removing the meter from the professional pipe or process, saving time and money.

The VeriCal In-Situ Calibration Verification System for the GF90 Flow Meter is the easiest, fastest, lowest cost way to confirm gas flow calibration accuracy to meet process validation, safety and environmental regulation requirements. Validating flow meter calibration has always been a labor intensive, costly and challenging exercise because the meters had to be pulled from the process, returned to the manufacturer or a calibration lab for testing and then shipped back for re-installation in the process.

The VeriCal System is a specially manufactured and plumbed GF90 flow element with additional electronics to feed and measure a precise flow of gas from a nitrogen source. To test a GF90 flow meter, the nitrogen gas is flowed through the meter’s flow element and measured at five pre-set measurement points across the meter’s range. The in-situ flow meter test data is then compared to original FCI laboratory calibration and installation benchmark test data for the meter.

The VeriCal System for the GF90 Flow Meter is ideal in applications for oil/gas production and refining, chemical plants and electric power generation, where periodic flow meter calibration validation is required by process or regulations.