The pressure transducer DMU/A measures the high, low and differential pressure between the two pressure inputs and transforms it to a linear output signal 0-10 V or 4-20 mA. There are 8 different pressure ranges for selection, which can be switched at will by innovative DIP-switch technology. The output attenuation (0 sec / 1 sec / 5 sec / 10 sec) can also be determined by DIP switch. For a manual calibration of the zero point on site the pressure transducer runs a zero point adjustment on keystroke. An additional offset controller can be used for fine calibration up to ± 5% relative to the selected measurement range.
standListOtherNews news di En 2012-05-21-23
