Circuit board for the parallel conversion of serial encoders with Standard SSI interface

The conversion board measuring 175mm x 70 mm can either be
panel mounted, using the four holes located in the corners, or DIN
guides in the version with support base-mounts (standard version).
This circuit board synchronises the data supplied by the SSI serial
encoder with a parallel port. It is possible to programme the serial
port encoder parameters using a remote control:
Zero - Pre-set - Auxiliary bits
and the parameters of the board:
Code: Gray/Binary - Up/Down - Latch - Synchronism
frequency: 250/500/1000KHz
The high density 30 LED bar displays the data converted to
parallel, consisting of 24 Bits, auxiliary Bits and control Bits.