By easy distortion of the “special supplier of clamping mechanism” the hotspring® heating element will be pressed along the total length of the mould to be heated .

Technical Data:
An optimal heat transition between heating element and tool

Front removal

No lift-off of heating element under temperature

Clamping mechanism without extension of outer diameter

Increase of the maximum sheath surface load (up to 10 W/cm2)

Adjustable to a wide range of diameters (several 1/10 mm)

Strong fit – no additional professional fasteners necessary

Material: stainless steel
Protection against mechanical damage

Can be combined with the hotspring® types

At least 4 windings of the heating element

Minimum length of clamp element : 40 mm

Minimum mould diameter: 10 mm
(with hotspring®/Micro/F/1.0x1.6)

Outer diameter:
(mould diameter + 2 x height of heating element + 2.3 mm, rounded to next millimeter, a maximum of 46 mm, other dimensions on request)

Easy assembly:
1. open heating element
2. slip heating element over tool
3. tighten heating element by torsion of “special clamping mechanism”